How To Install A Electric Chain Hoist?

• Things to create positive before installation: The electric chain hoist and trolley are prepackaged severally. first, check if the number of the hoist accords with the number of units in the invoice and if their area unit any damages occurred from the transportation or abnormal packing. Also, Check the plate and see if the rated capacity, lifting speed, lifting height, cross traveling speed in addition because the power provide is up to plain. Check if screws of prime hook set are loosed and if the chains are knotted and twisted.

1.Check the track where the hoist and trolley combo is to be mounted: The run track of the hoist adopted is the I- Beam steel. The range of width is 75-180 mm for 1T - 2T and 100-180 mm for 3T-5T. The track for running should be smooth and its swerve radius cannot but the minimum radius stipulated within the plate. the location of axle height at the tip of the track should be mounted a physical property buffer to ensure the safe running of the trolley.


2.Assemble the hoist and trolley: once assembling, the number of adjustment washers for right and left between the flying ring and both sides’ plates should be equal. more one thin piece of adjustment washer shall be allowed in order to ensure the clearance of three mm between the flank and flange of the track. For the max or minimum dimension of the track, there should be one piece of washer a minimum of.

3.Installation for the whole hoist: Tighten the nuts inboard of the beam after the hoist is mounted on the track. And have a take a look at the run with the lightweight load. Tighten the nuts outboard of the beam once the wheel contacts the track fully. listen particularly that the nuts inboard of the beam should interlock the nuts outboard.

4.The clearance between the roller and also the bottom of track ought to be adjusted to 3 mm. The method of adjustment is loose the nuts of the roller and move the roller, tighten the nuts once the clearance is up to plain.